How To Reset Kenmore Dishwasher

To reset your Kenmore dishwasher, press the “Heated Dry” and “Normal Wash” buttons in succession: Heated Dry, Normal Wash, Heated Dry, Normal Wash. This sequence should initiate a reset, indicated by all lights illuminating on the control panel. If this doesn’t resolve the issue, a hard reset by disconnecting the power supply may be necessary.

---

Comprehensive Guide to Resetting Your Kenmore Dishwasher

Kenmore dishwashers are designed to provide reliable performance, but occasional glitches may require a reset to restore normal operation. This guide offers detailed instructions on various reset methods tailored to different Kenmore models.

1. Understanding the Need for a Reset

Common scenarios that may necessitate a reset include:

• Unresponsive Control Panel: Buttons fail to respond or are unresponsive.
• Interrupted Wash Cycles: Cycles that stop unexpectedly and do not resume.
• Error Codes: Display of error messages indicating specific malfunctions.

Identifying these issues can help determine when a reset is appropriate.

2. Soft Reset Procedure

A soft reset can resolve minor issues without disrupting the appliance’s settings:

• Method: Press the “Heated Dry” button, followed by the “Normal Wash” button. Repeat this sequence: Heated Dry, Normal Wash, Heated Dry, Normal Wash. This action should reset the control panel, indicated by all lights illuminating.
• Note: This method is effective for models with these specific buttons.

3. Hard Reset Procedure

For persistent issues, a hard reset may be necessary:

• Method:
  1. Disconnect Power: Unplug the dishwasher from the electrical outlet or switch off the circuit breaker supplying power to the appliance.
  2. Wait Period: Leave the dishwasher disconnected for approximately 10-15 minutes to allow residual power to dissipate.
  3. Restore Power: Reconnect the dishwasher to the power source or turn the circuit breaker back on.
  4. Test Operation: Run a short wash cycle to ensure the dishwasher functions correctly.
• Note: This method applies to all Kenmore dishwasher models.

4. Model-Specific Reset Methods

Different Kenmore models may have unique reset procedures:

• Kenmore Elite Models: Press the “Heated Dry” button for three seconds, then immediately press and release the “Start” button.
• Kenmore Ultra Wash Models: Press “Normal Wash,” then “Heated Dry,” repeating this sequence until all lights illuminate, then press “Cancel” to complete the reset.

Refer to your user manual for model-specific instructions.

5. Troubleshooting Persistent Issues

If resetting does not resolve the problem:

• Check Door Latch: Ensure the door is properly closed and latched, as the dishwasher will not operate if the door is ajar.
• Inspect for Error Codes: Consult the user manual to interpret any error codes displayed and follow the recommended troubleshooting steps.
• Examine Power Supply: Verify that the dishwasher is receiving power by checking the circuit breaker and ensuring the outlet functions correctly.
• Assess Water Supply: Confirm that the water inlet valve is open and supplying water to the dishwasher.

If issues persist after these checks, consider contacting a professional technician for further assistance.